Dell MXL 10GbE - Interface te; Storm-Control Broadcast (Configuration)

Parameters
interface (OPTIONAL) Enter one of the following interfaces to display
the interface specific storm control configuration:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Example
Dell#show storm-control unknown-unicast tengigabitethernet 3/0
Unknown-unicast storm control configuration
Interface Direction Packets/Second
----------------------------------------
TenGig 3/0 Ingress 1000
Dell#
storm-control broadcast (Configuration)
Configure the percentage of broadcast traffic allowed in the network.
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast rate-limiting, use the no storm-control broadcast
[
packets_per_second in] command.
Parameters
packets_per_se
cond
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Defaults none
Command
Modes
CONFIGURATION (conf)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2
broadcast traffic is treated as unknown-unicast traffic.
1266
Storm Control