Dell MXL 10GbE - Tc-Flush-Standard

Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Usage
Information
Some non-Dell Networking systems which have hybrid ports participating in PVST+
transmit two kinds of BPDUs: an 802.1D BPDU and an untagged PVST+ BPDU.
Dell Networking systems do not expect PVST+ BPDU on an untagged port. If this
happens, the system places the port in the Error-Disable state. This behavior might
result in the network not converging. To prevent the system from executing this
action, use the no spanning-tree pvst err-disable command cause
invalid-pvst-bpdu.
Related
Commands
show spanning-tree pvst — views the PVST+ configuration.
tc-flush-standard
Enable the MAC address flushing after receiving every topology change notification.
Syntax
tc-flush-standard
To disable, use the no tc-flush-standard command.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
By default, the system implements an optimized flush mechanism for PVST+. This
implementation helps in flushing the MAC addresses only when necessary (and less
often) allowing for faster convergence during topology changes. However, if a
standards-based flush mechanism is needed, you can turn this knob command on
to enable flushing MAC addresses after receiving every topology change
notification.
vlan bridge-priority
Set the PVST+ bridge-priority for a VLAN or a set of VLANs.
Syntax
vlan vlan-id bridge-priority value
To return to the default value, use the no vlan bridge-priority command.
1068
Per-VLAN Spanning Tree Plus (PVST+)