Dell MXL 10GbE - Ip Dhcp Source-Address-Validation

Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip dhcp source-address-validation
Enable the IP Source Guard.
Syntax
[no] ip dhcp source-address-validation [ipmac]
Parameters
ipmac Enable IP+MAC Source Address Validation.
Defaults Disabled
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Allocate at least one FP block to ipmacacl before you can enable IP+MAC Source
Address Validation.
1. Use the cam-acl l2acl command from CONFIGURATION mode.
2. Save the running-config to the startup-config.
3. Reload the system.
ip dhcp snooping vlan
Enable DHCP Snooping on one or more VLANs.
Syntax
[no] ip dhcp snooping vlan name
Parameters
name Enter the name of a VLAN on which to enable DHCP
Snooping.
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When enabled, the system begins creating entries in the binding table for the
specified VLANs.
500
Dynamic Host Configuration Protocol (DHCP)