Dell MXL 10GbE - Release Dhcp Interface

Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
release dhcp interface
Release the dynamically-acquired IP address on an Ethernet interface while retaining the DHCP client
configuration on the interface.
Syntax
release dhcp interface type slot/port
Parameters
interface type
slot/port
• For a 10-GigabitEthernet Ethernet interface, enter
TenGigabitEthernet then the slot/port numbers; for
example, tengigabitethernet 1/3.
• For a 40-GigabitEthernet Ethernet interface, enter
FortyGigabitEthernet then the slot/port numbers;
for example, fortygigabitethernet 0/2.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enter the release dhcp command, although the IP address that was
dynamically-acquired from a DHCP server is released from an interface, the ability
to acquire a new DHCP server-assigned address remains in the running
configuration for the interface. To acquire a new IP address, enter either the renew
dhcp command at the EXEC privilege level or the ip address dhcp command at
the Interface Configuration level.
renew dhcp interface
Re-acquire a dynamic IP address on an Ethernet interface enabled as a DHCP client.
Syntax
renew dhcp interface type slot/port
Parameters
interface type
slot/port
• For a 10-GigabitEthernet Ethernet interface, enter
TenGigabitEthernet then the slot/port numbers; for
example,
tengigabitethernet 1/3.
494
Dynamic Host Configuration Protocol (DHCP)