Dell MXL 10GbE - Feature Fip-Snooping

fcf-mac-
address
Enter the FCF MAC address to be cleared of FIP snooping
information.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
clear fip-snooping statistics
Clears the statistics on the FIP packets snooped on all VLANs, a specified VLAN, or a specified port
interface.
Syntax
clear fip-snooping statistics [interface vlan vlan-id |
interface port-type port/slot | interface port-channel port-
channel-number]
Parameters
vlan-id Enter the VLAN ID of the FIP packet statistics to be cleared.
port-type port/
slot
Enter the port-type and slot number of the FIP packet
statistics to be cleared.
port-channel-
number
Enter the port channel number of the FIP packet statistics to
be cleared.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
feature fip-snooping
Enable FCoE transit and FIP snooping on a switch.
Syntax
feature fip-snooping
To disable the FCoE transit feature, use the no feature fip-snooping
command.
Defaults Disabled
Command
Modes
CONFIGURATION
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1457