Dell MXL 10GbE - Bgp Graceful-Restart

Usage
Information
Routers supporting 4-byte ASNs advertise that function in the OPEN message. The
behavior of a 4-byte router is slightly different depending on whether it is speaking
to a 2-byte router or a 4-byte router.
When creating Confederations, all the routers in the Confederation must be 4 byte
or 2 byte identified routers. You cannot mix them.
Where the 2-byte format is from 1 to 65535, the 4-byte format is from 1 to
4294967295. Both formats are accepted and the advertisements reflect the
entered format.
For more information about using the 2 byte or 4-byte format, refer to the Dell
Networking OS Configuration Guide.
bgp graceful-restart
To support graceful restart as a receiver only, enable graceful restart on a BGP neighbor, a BGP node, or
designate a local router.
Syntax
bgp graceful-restart [restart-time seconds] [stale-path-time
seconds] [role receiver-only]
To return to the default, use the no bgp graceful-restart command.
Parameters
restart-time
seconds
Enter the keyword restart-time then the maximum
number of seconds to restart and bring-up all the peers. The
range is from 1 to 3600 seconds. The default is 120 seconds.
stale-path-time
seconds
Enter the keyword stale-path-time then the maximum
number of seconds to wait before restarting a peer’s stale
paths. The default is 360 seconds.
role receiver-
only
Enter the keyword role receiver-only to designate the
local router to support graceful restart as a receiver only.
Defaults as above
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This feature is advertised to BGP neighbors through a capability advertisement. In
Receiver Only mode, BGP saves the advertised routes of peers that support this
capability when they restart.
Border Gateway Protocol IPv4 (BGPv4)
323