Dell MXL 10GbE - Clear Host

ip ip-address (OPTIONAL) Enter the keyword ip then the IP address of the
ARP entry you wish to clear.
no-refresh (OPTIONAL) Enter the keywords no-refresh to delete the
ARP entry from CAM. Or use this option with
interface or
ip ip-address to specify which dynamic ARP entries you
want to delete.
NOTE: Transit traffic may not be forwarded during the
period when deleted ARP entries are resolved again and
re-installed in CAM. Use this option with extreme
caution.
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
clear host
Remove one or all dynamically learned host table entries.
Syntax
clear host name
Parameters
name Enter the name of the host to delete. Enter * to delete all
host table entries.
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
clear ip fib stack-unit
Clear all forwarding information base (FIB) entries in the specified stack unit (use this command with
caution, refer to Usage Information.)
Syntax
clear ip fib stack-unit unit-number
Parameters
unit-number Enter the number of the stack unit. The range is from 0 to 5.
Command
Modes
EXEC
EXEC Privilege
616
IPv4 Routing