Dell MXL 10GbE - Set Metric-Type

set metric-type
To assign a new route type for routes redistributed to OSPF, configure a filter.
Syntax
set metric-type {internal | external | type-1 | type-2}
Parameters
internal Enter the keyword internal to assign the Interior Gateway
Protocol metric of the next hop as the route’s BGP
MULTI_EXIT_DES (MED) value.
external Enter the keyword external to assign the IS-IS external
metric.
type-1 Enter the keyword type-1 to assign the OSPF Type 1 metric.
type-2 Enter the keyword type-2 to assign the OSPF Type 2 metric.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
set automatic-tag — computes the tag value of the route.
set metric — specifies the metric value assigned to redistributed routes.
set tag — specifies the tag assigned to redistributed routes.
set tag
To specify a tag for redistributed routes, configure a filter.
Syntax
set tag tag-value
Parameters
tag-value Enter a number as the tag. The range is from zero (0) to
4294967295.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
set automatic-tag — computes the tag value of the route.
set metric — specifies the metric value assigned to redistributed routes.
Access Control Lists (ACL)
209