monitor interface
Monitor counters on a single interface or all interfaces on a line card. The screen is refreshed every five
seconds and the CLI prompt disappears.
Syntax
monitor interface [interface]
To disable monitoring and return to the CLI prompt, press the q key.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For the management port, enter the keyword
managementethernet then the slot (0 or 1) and the port
(0).
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
In the Example, the delta column displays changes since the last screen refresh.
The following are the monitor command menu options.
Key Description
systest-3 Displays the host name assigned to the system.
monitor time Displays the amount of time since the monitor
interface command was entered.
time Displays the amount of time the chassis is up (since last
reboot).
m Change the view from a single interface to all interfaces on
the line card or visa-versa.
c Refresh the view.
b Change the counters displayed from Packets on the
interface to Bytes.
r Change the [delta] column from change in the number of
packets/bytes in the last interval to rate per second.
Interfaces
571
To Next Page
Loading...
