Dell MXL 10GbE - Debug Vrrp Ipv6

debug vrrp ipv6
Allows you to enable debugging of VRRP.
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state |
timer}
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel
then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
vrid (OPTIONAL) Enter a number from 1 to 255 as the VRRP
group ID.
all Enter the keyword all to enable debugging of all VRRP
groups.
packets Enter the keyword packets to enable debugging of VRRP
control packets.
state Enter the keyword state to enable debugging of VRRP state
changes
timer Enter the keyword timer to enable debugging of the VRRP
timer.
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the system returns No Active
VRRP group
.
Syntax
show vrrp ipv6 [vrid] [interface] [brief]
Parameters
vrid (OPTIONAL) Enter the virtual router identifier for the VRRP
group to view only that group. The range is from 1 to 255.
1358
Virtual Router Redundancy Protocol (VRRP)