radius-server timeout
To reply to a request, configure the amount of time the RADIUS client (the switch) waits for a RADIUS
host server .
Syntax
radius-server timeout seconds
To return to the default value, use the no radius-server timeout command.
Parameters
seconds Enter the number of seconds between an unsuccessful
attempt and the system times out. The range is from zero (0)
to 1000 seconds. The default is 5 seconds.
Defaults 5 seconds
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
radius-server host — configures a RADIUS host.
role
Changes command permissions for roles.
Syntax role mode { { { addrole | deleterole } role-name } | reset } command
To delete access to a command, use the no role mode role-name
Parameters
mode
Enter one of the following keywords as the mode for which
you are controlling access:
configure for CONFIGURATION mode
exec for EXEC mode
interface for INTERFACE modes
line for LINE mode
route-map for Route-map mode
router for Router mode
Security
1179
To Next Page
Loading...
