Dell MXL 10GbE - Advertise Med Power-Via-MDI

show running-config lldp — displays the LLDP running configuration.
advertise med power-via-mdi
To advertise the Extended Power via MDI TLV, configure the system.
Syntax
advertise med power-via-mdi
To return to the default, use the no advertise med power-via-mdi command.
Defaults unconfigured.
Command
Modes
CONFIGURATION (conf-lldp)
Command
History
Version 8.3.16.1
Usage
Information
Advertise the Extended Power via MDI on all ports that are connected to an 802.3af
powered, LLDP-MED endpoint device.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
advertise med softphone-voice
To advertise softphone to enable IP telephony on a computer so that the computer can be used as a
phone, configure the system.
Syntax
advertise med softphone-voice {vlan-id} | {priority-tagged
number}
To return to the default, use the no advertise med softphone-voice
{vlan-id} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
priority-tagged
number
Enter the keywords priority-tagged then the Layer 2
priority. The range is from 0 to 7.
Defaults unconfigured.
Command
Modes
CONFIGURATION (conf-lldp)
Link Layer Discovery Protocol (LLDP)
877