Dell MXL 10GbE - Show Interfaces Dampening

Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:04:59
Dell#
Related
Commands
show interfaces — displays information on a specific physical interface or virtual
interface.
show interfaces dampening
Display interface dampening information.
Syntax
show interfaces dampening [[interface] [summary] [detail]]
Parameters
interface (Optional) Enter one of the following keywords and slot/port
or number information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
summary (OPTIONAL) Enter the keyword summary to display the
current summary of dampening data, including the number
of interfaces configured and the number of interfaces
suppressed, if any.
detail (OPTIONAL) Enter the keyword detail to display detailed
interface dampening data.
Defaults none
Command
Modes
EXEC
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show interfaces dampening
Interface Supp Flaps Penalty Half-Life Reuse Suppress Max-Sup
State
Gi 3/2 Up 0 0 20 800 4500 120
Gi 3/10 Up 0 0 5 750 2500 20
Dell#
Related
Commands
dampening— configures dampening on an interface.
show interfaces — displays information on a specific physical interface or virtual
interface.
Interfaces
585