Dell MXL 10GbE - Protocol Spanning-Tree Mstp

protocol spanning-tree mstp
To enable and configure the multiple spanning tree group, enter MULTIPLE SPANNING TREE mode.
Syntax
protocol spanning-tree mstp
To disable the multiple spanning tree group, use the no protocol spanning-
tree mstp command.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
MSTP is not enabled when you enter MULTIPLE SPANNING TREE mode. To enable
MSTP globally on the switch, enter the no disable command while in MULTIPLE
SPANNING TREE mode.
For more information about the multiple spanning tree protocol, refer to the Dell
Networking OS Configuration Guide.
Example
Dell(conf)#protocol spanning-tree mstp
Dell(config-mstp)#no disable
Related
Commands
disable — disables multiple spanning tree.
revision
The revision number for the multiple spanning tree configuration.
Syntax
revision range
To return to the default values, use the no revision command.
Parameters
range Enter the revision number for the MST configuration. The
range is from 0 to 65535. The default is 0.
Defaults 0
Command
Modes
MULTIPLE SPANNING TREE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
904
Multiple Spanning Tree Protocol (MSTP)