graceful-restart t1
Set the graceful restart wait time before unacknowledged restart requests are generated. This wait time is
the interval before the system sends a restart request (an IIH with RR bit set in Restart TLV) until the CSNP
is received from the helping router.
Syntax
graceful-restart t1 {interval seconds | retry-times value}
To return to the default, use the no graceful-restart t1 command.
Parameters
interval Enter the keyword interval to set the wait time. The range
is from 5 to 120 seconds. The default is 5 seconds.
retry-times Enter the keywords retry-times to set the number of
times the request interval is extended until a CSNP is
received from the helping router. The range is from 1 to 10
attempts. The default is 1.
Defaults Refer to Parameters.
Command
Modes
ROUTER ISIS
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
graceful-restart t2
Configure the wait time for the graceful restart timer T2 that a restarting router uses as the wait time for
each database to synchronize.
Syntax
graceful-restart t2 {level-1 | level-2} seconds
To return to the default, use the no graceful-restart t2 command.
Parameters
level-1, level-2 Enter the keywords level-1 or level-2 to identify the
database instance type to which the wait interval applies.
seconds Enter the gracefule-restart t2 time in seconds. The
range is from 5 to 120 seconds. The default is
30 seconds.
Defaults 30 seconds
Command
Modes
ROUTER ISIS
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Intermediate System to Intermediate System (IS-IS)
805
To Next Page
Loading...
