Dell MXL 10GbE - Flow-Based Enable

Version 8.3.16.1 Introduced on the M I/O Aggregator.
Related
Commands
monitor session — enables a monitoring session.
flow-based enable
Enable flow-based monitoring.
Syntax
flow-based enable
To disable flow-based monitoring, use the no flow-based enable command.
Defaults Disabled, that is flow-based monitoring is not applied.
Command
Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
Version 9.4(0.0) Added support for the RPM/ERPM.
Version 9.3(0.0) Introduced on the MXL 10/40GbE Switch IO Module
platform.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
To monitor traffic with particular flows the interface, appropriate ACLs has be
applied in ingress direction. Flow- based is not supported in the tx direction. Even
though we can configure it in both the direction, only rx will work.
The flow- based enable command has to be applied as a monitor session with
some configuration which is already present in it, other wise flow- based will not
take effect.
Related
Commands
monitor session – enables a monitoring session.
monitor session
Create a session for monitoring traffic with port monitoring.
Syntax
monitor session session-ID (type { rpm | erpm })
To delete a session, use the no monitor session session-ID command.
To delete all monitor sessions, use the no monitor session all command.
Port Monitoring
1045