Dell MXL 10GbE - Bfd Enable (Configuration)

Command
Modes
INTERFACE VRRP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
bfd enable (Configuration)
Enable BFD on all interfaces.
Syntax
bfd enable
Disable BFD using the no bfd enable command.
Defaults BFD is disabled by default.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
bfd enable (Interface)
Enable BFD on an interface.
Syntax
bfd enable
Defaults BFD is enabled on all interfaces when you enable BFD from CONFIGURATION
mode.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
bfd interval
Specify non-default BFD session parameters beginning with the transmission interval.
Syntax
bfd interval interval min_rx min_rx multiplier value role
{active | passive}
300
Bidirectional Forwarding Detection (BFD)