Dell MXL 10GbE - Advertise Med Location-Identification

Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
advertise med location-identification
To advertise a location identifier, configure the system.
Syntax
advertise med location-identification {coordinate-based value |
civic-based value | ecs-elin value}
To return to the default, use the no advertise med location-
identification {coordinate-based value | civic-based value |
ecs-elin value} command.
Parameters
coordinate-
based value
Enter the keywords coordinate-based then the
coordinated based location in hexadecimal value of 16 bytes.
civic-based
value
Enter the keywords civic-based then the civic based
location in hexadecimal format. The range is from 6 to 255
bytes.
ecs-elin value Enter the keywords ecs-elin then the Emergency Call
Service (ecs) Emergency Location Identification Number
(elin) numeric location string. The range is from 10 to 25
characters.
Defaults unconfigured.
Command
Modes
CONFIGURATION (conf-lldp)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
• ECS — Emergency call service such as defined by TIA or the national
emergency numbering association (NENA)
• ELIN — Emergency location identification number, a valid North America
Numbering Plan format telephone number supplied for ECS purposes.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
876
Link Layer Discovery Protocol (LLDP)