Dell MXL 10GbE - Duplex (1000;10000 Interfaces)

Defaults none
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Important Points to Remember:
• Spaces between characters are not preserved after entering this command
unless you enclose the entire description in quotation marks (“desc_text”).
• Entering a text string after the description command overwrites any previous
text string that you previously configured as the description.
• The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port-channel.
• Use the show interfaces description command to display descriptions
configured for each interface.
Related
Commands
show interfaces description — displays the description field of the interfaces.
duplex (1000/10000 Interfaces)
Configure duplex mode on any physical interfaces where the speed is set to 1000/10000.
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half Enter the keyword half to set the physical interface to
transmit only in one direction.
full Enter the keyword full to set the physical interface to
transmit in both directions.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
558
Interfaces