Dell MXL 10GbE - Clear Isis

clear isis
Restart the IS-IS process. All IS-IS data is cleared.
Syntax
clear isis [tag] {* | database | traffic}
Parameters
tag (Optional) Enter an alphanumeric string to specify the IS-IS
routing tag area.
* Enter the keyword * to clear all IS-IS information and restart
the IS-IS process. This command removes IS-IS neighbor
information and IS-IS LSP database information and the full
SPF calculation is done.
database Clears IS-IS LSP database information.
traffic Clears IS-IS counters.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
clns host
Define a name-to-network service mapping point (NSAP) that you use with commands that require
NSAPs and system IDs.
Syntax
clns host name nsap
Parameters
name Enter an alphanumeric string to identify the name-to-NSAP
mapping.
nsap Enter a specific NSAP address that is associated with the
name parameter.
Defaults Not configured.
Command
Modes
ROUTER ISIS
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To configure a shortcut name that you can use instead of entering a long string of
numbers associated with an NSAP address, use this command.
Related
Commands
hostname dynamic — enables dynamic learning of host names from routers in the
domain and allows the routers to advertise the host names in LSPs.
Intermediate System to Intermediate System (IS-IS)
795