Dell MXL 10GbE - Source (Port Monitoring)

• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the M I/O Aggregator.
Usage
Information
The monitoring command is saved in the running configuration at the Monitor
Session mode level and can be restored after a chassis reload.
Example
Dell# show running-config monitor session
!
monitor session 1
source TenGigabitEthernet 0/1 destination TenGigabitEthernet
0/2 direction rx
Related
Commands
monitor session — creates a session for monitoring.
show monitor session — displays a monitor session.
source (port monitoring)
Configure a port monitor source.
Syntax
source interface | range destination interface direction {rx |
tx | both}
To disable a monitor source, use the no source interface destination
interface direction {rx | tx | both} command.
Parameters
source
interface
Enter the one of the following keywords and slot/port
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface enter the keyword VLAN then by a
number range from 1 to 4094.
• For a port channel interface, enter the keyword LAG then
port channel and the port-channel id .
range Enter the keyword range to specify a list of interfaces.
destination Enter the keyword destination to specify the destination
interface.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
1048
Port Monitoring