Dell MXL 10GbE - Auto-Cost

Defaults Disabled.
Command
Modes
ROUTER OSPF
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To configure all routers and access servers within a stub, use this command.
Related
Commands
router ospf — enters ROUTER OSPF mode to configure an OSPF instance.
auto-cost
Specify how the OSPF interface cost is calculated based on the reference bandwidth method.
Syntax
auto-cost [reference-bandwidth ref-bw]
To return to the default bandwidth or to assign cost based on the interface type,
use the no auto-cost [reference-bandwidth] command.
Parameters
ref-bw (OPTIONAL) Specify a reference bandwidth in megabits per
second. The range is from 1 to 4294967. The default is 100
megabits per second.
Defaults 100 megabits per second.
Command
Modes
ROUTER OSPF
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
clear ip ospf
Clear all OSPF routing tables.
Syntax
clear ip ospf process-id [process]
Parameters
process-id Enter the OSPF Process ID to clear a specific process. If no
Process ID is entered, all OSPF processes are cleared.
process (OPTIONAL) Enter the keyword process to reset the OSPF
process.
Open Shortest Path First (OSPFv2 and OSPFv3)
927