Dell MXL 10GbE - Ip Pim Spt-Threshold

Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command configures an expiration timer for all S.G entries, unless they are
assigned to an Extended ACL.
ip pim spt-threshold
To switch to the shortest path tree when the traffic reaches the specified threshold value, configure the
PIM router.
Syntax
ip pim spt-threshold value | infinity
To return to the default value, use the no ip pim spt-threshold command.
Parameters
value (OPTIONAL) Enter the traffic value in kilobits per second. The
default is 10 packets per second. A value of zero (0) causes a
switchover on the first packet.
infinity (OPTIONAL) Enter the keyword infinity to never switch to
the source-tree.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command is applicable to last hop routers on the shared tree towards the
rendezvous point (RP).
no ip pim snooping dr-flood
Disable the flooding of multicast packets to the PIM designated router.
Syntax
no ip pim snooping dr-flood
To re-enable the flooding of multicast packets to the PIM designated router, use
the ip pim snooping dr-flood command.
Defaults Enabled.
1022
PIM-Sparse Mode (PIM-SM)