Dell MXL 10GbE - Neighbor Next-Hop-Self

neighbor next-hop-self
Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for IBGP).
Syntax
neighbor {ipv6-address | peer-group-name} next-hop-self
To return to the default setting, use the no neighbor {ipv6-address | peer-
group-name} next-hop-self command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
(OPTIONAL) Enter the name of the peer group.
Defaults Disabled.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you configure the set ipv6 next-hop command in ROUTE-MAP mode, its
configuration takes precedence over the neighbor next-hop-self command.
neighbor peer-group (assigning peers)
Allows you to assign one peer to a existing peer group.
Syntax
neighbor ipv6-address peer-group peer-group-name
To delete a peer from a peer group, use the no neighbor ipv6-address
peer-group peer-group-name command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group
peer-group-
name
Enter the keywords peer-group then the name of a
configured peer group (maximum 16 characters).
Defaults Not configured.
Command
Modes
ROUTER BGP
IPv6 Border Gateway Protocol (IPv6 BGP)
729