peer-group-
name
Enter the name of the peer group to remove the private AS
numbers.
Defaults Disabled (that is, the private AS number are not removed).
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Applies to external border gateway protocol (EBGP) neighbors only.
If the AS-PATH contains both public and private AS number or contains AS
numbers of an EBGP neighbor, the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software
removes the private AS numbers only if they follow the confederation numbers in
the AS path.
Private AS numbers are from 64512 to 65535.
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
Syntax
neighbor {ipv6-address | peer-group-name} route-map map-name
{in | out}
To remove the route map, use the no neighbor {ipv6-address | peer-
group-name} route-map map-name {in | out} command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group.
map-name Enter the name of an established route map. If the Route
map is not configured, the default is deny (to drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
IPv6 Border Gateway Protocol (IPv6 BGP)
733
To Next Page
Loading...
