Dell MXL 10GbE - Ipv6 Pim Rp-Candidate

Parameters
address Enter the IPv6 RP address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
group-address
group-address
mask
Enter the keywords group-address then the group address
in the x:x:x:x::x format and then the mask in /nn format to
assign that group address to the RP.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
override Enter the keyword override to override the BSR updates
with static RP. The override takes effect immediately during
enable/disable.
NOTE: This option is applicable to multicast group range.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The RP addresses are stored in the order in which they are entered. RP addresses
learned via BSR take priority over static RP addresses.
Without the override option, the BSR-advertised RPs updates take precedence over
the statically configured RPs.
ipv6 pim rp-candidate
Specify an interface as an RP candidate.
Syntax
ipv6 pim rp-candidate interface [priority-value]
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
1038
PIM-Sparse Mode (PIM-SM)