Field Description
Flaps Displays the number of times the route flapped.
Duration Displays the hours:minutes:seconds since the route first
flapped.
Reuse Displays the hours:minutes:seconds until the flapped route
is available.
Path Lists all the ASs the flapping route passed through to reach
the destination network.
Example
Dell>show ip bgp flap-statistics
BGP table version is 210851, local router ID is 63.114.8.2
Status codes: s suppressed, d damped, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Flaps Duration Reuse
Path
Dell>
show ip bgp inconsistent-as
View routes with inconsistent originating autonomous system (AS) numbers; that is, prefixes that are
announced from the same neighbor AS but with a different AS-Path.
Syntax
show ip bgp [ipv4 unicast] inconsistent-as
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip bgp inconsistent-as command shown
in the following example.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then local routes exist in the routing
table.
Metric Displays the BGP route’s metric, if assigned.
Border Gateway Protocol IPv4 (BGPv4)
375
To Next Page
Loading...
