Dell MXL 10GbE - Disable

packet (OPTIONAL) Enter the keyword packet to display
information regarding packets coming in or going out.
brief (OPTIONAL) Enter the keyword brief to display brief packet
information.
detail (OPTIONAL) Enter the keyword detail to display detailed
packet information.
tx (OPTIONAL) Enter the keyword tx to display transmit-only
packet information.
rx (OPTIONAL) Enter the keyword rx to display receive-only
packet information.
both (OPTIONAL) Enter the keyword both to display both receive
and transmit packet information.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
disable
Enable or disable LLDP.
Syntax
disable
To enable LLDP, use the no disable command.
Defaults Enabled, that is no disable.
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
protocol lldp (Configuration) — enables LLDP globally.
debug lldp interface — debugs LLDP.
Link Layer Discovery Protocol (LLDP)
869