Dell MXL 10GbE - Page 826

To return to the default values, use the no redistribute bgp command with
the appropriate parameters.
Parameters
AS number Enter a number that corresponds to the autonomous system
number. The range is from 1 to 65355.
level-1 (OPTIONAL) Routes are independently redistributed into IS-
IS Level 1 routes only.
level-1-2 (OPTIONAL) Routes are independently redistributed into IS-
IS Level 1 and Level 2 routes.
level-2 (OPTIONAL) Routes are independently redistributed into IS-
IS as Level 2 routes only. This setting is the default.
metric metric-
value
(OPTIONAL) The value used for the redistributed route. Use a
metric value that is consistent with the destination protocol.
The range is from 0 to 16777215. The default is 0.
metric-type
{external|
internal}
(OPTIONAL) The external link type associated with the
default route advertised into a routing domain. The two
options are:
• external
• internal
route-map
map-name
map-name is an identifier for a configured route map. The
route map filters imported routes from the source routing
protocol to the current routing protocol.
If you do not specify a map-name, all routes are
redistributed. If you specify a keyword, but fail to list route
map tags, no routes are imported.
Defaults IS-IS Level 2 routes only
Command
Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
BGP to IS-IS redistribution supports “match” options using route maps. You can set
the metric value, level, and metric-type of redistributed routes by the redistribution
command. You can “set” more advanced options using route maps.
Example
Dell(conf)#router is
Dell(conf-router_isis)#redistribute bgp 1 level-1 metric 32
metric-type
external route-map rmap-isis-to-bgp
Dell(conf-router_bgp)#show running-config isis
!
router isis
redistribute bgp 1 level-1 metric 32 metric-type external
826
Intermediate System to Intermediate System (IS-IS)