Defaults none
Command
Modes
REDIRECT-LIST
Command
History
Version 9.4.0.0 Introduced on the MXL 10/40GbE Switch IO Module.
Version 8.4.2.1 Introduced on the C-Series.
Version 8.4.2.0 Introduced on the E-Series TeraScale.
seq
Configure a filter with an assigned sequence number for the redirect list.
Syntax
seq sequence-number {permit | redirect {ip-address}} {ip-
protocol-number | protocol-type} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [bit]
[operator]{source-port source-port| source-port-range start-
port - end-port} {destination-port destination-port|
destination-port-range start-port - end-port}
To delete a filter, use the no seq sequence-number command.
Parameters
sequence-
number
Enter a number from 1 to 65535.
permit Enter the keyword permit assign the sequence to the
permit list.
redirect Enter the keyword redirect to assign the sequence to the
redirect list.
ip-address Enter the IP address of the forwarding router.
ip-protocol-
number
Enter the keyword ip-protocol-number then the number
from 0 to 255 for the protocol identified in the IP protocol
header.
protocol-type Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x).
Policy-based Routing (PBR)
1009
To Next Page
Loading...
