Enter a multicast group address and, optionally, a source
multicast address in dotted decimal format (A.B.C.D) to limit
the information displayed to the multicast routes PIM-SM
snooping discovers for a specified multicast group and
source.
summary (OPTIONAL) Enter the keyword summary to view routes in a
tabular format.
vlt (OPTIONAL) Enter the keyword vlt to view multicast routes
with a spanned incoming interface. Enter a multicast group
address in dotted decimal format (A.B.C.D) to limit the
information displayed to the multicast routes for a specified
multicast group.
count Enter the keyword count to display VLT route and packet
data.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip mroute command shown in the examples.
Field Description
(S, G) Displays the forwarding entry in the multicast route table.
uptime Displays the amount of time the entry has been in the
multicast forwarding table.
Incoming
interface
Displays the reverse path forwarding (RPF) information
towards the source for (S,G) entries and the RP for (*,G)
entries.
Outgoing
interface list:
Lists the interfaces that meet one of the following:
• a directly connected member of the Group
• statically configured member of the Group
• received a (*,G) or (S,G) Join message
Example (static)
Dell#show ip mroute static
Mroute: 23.23.23.0/24, interface: Lo 2
Protocol: static, distance: 0, route-map: none, last change:
00:00:23
Example
(snooping)
Dell#show ip mroute snooping
IPv4 Multicast Snooping Table (*, 224.0.0.0), uptime 17:46:23
Incoming vlan: Vlan 2
Outgoing interface list:
GigabitEthernet 4/13
1336
Virtual Link Trunking (VLT)
To Next Page
Loading...
