Dell MXL 10GbE - Page 137

Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you enable 802.1X multi-supplicant authentication on a port, additional 802.1X
configuration details (Port Authentication status, Untagged VLAN ID, Authentication
PAE state, and Backend state) are displayed for each supplicant, as shown in the
following example.
Example
Dell#show dot1x interface fortyGigE 0/48
802.1x information on Fo 0/48:
-----------------------------
Dot1x Status: Enable
Port Control: AUTO
Port Auth Status: UNAUTHORIZED
Re-Authentication: Disable
Untagged VLAN id: None
Guest VLAN: Disable
Guest VLAN id: NONE
Auth-Fail VLAN: Disable
Auth-Fail VLAN id: NONE
Auth-Fail Max-Attempts: NONE
Mac-Auth-Bypass: Disable
Mac-Auth-Bypass Only: Disable
Tx Period: 30 seconds
Quiet Period: 60 seconds
ReAuth Max: 2
Supplicant Timeout: 30 seconds
Server Timeout: 30 seconds
Re-Auth Interval: 3600 seconds
Max-EAP-Req: 2
Host Mode: SINGLE_HOST
Auth PAE State: Initialize
Backend State: Initialize
Dell#
Dell#show dot1x interface tengigabitethernet 0/32
802.1x information on Te 0/32:
-----------------------------
Dot1x Status: Enable
Port Control: AUTO
Port Auth Status: AUTHORIZED(MAC-AUTH-BYPASS)
Re-Authentication: Disable
Untagged VLAN id: 400
Guest VLAN: Enable
Guest VLAN id: 100
Auth-Fail VLAN: Disable
Auth-Fail VLAN id: NONE
Auth-Fail Max-Attempts: NONE
Mac-Auth-Bypass: Enable
Mac-Auth-Bypass Only: Enable
Tx Period: 3 seconds
Quiet Period: 60 seconds
ReAuth Max: 2
Supplicant Timeout: 30 seconds
Server Timeout: 30 seconds
Re-Auth Interval: 3600 seconds
Max-EAP-Req: 2
Host Mode: SINGLE_HOST
Auth PAE State: Authenticated
802.1X
137