Dell MXL 10GbE - Page 1375

show dcb-map
Display the DCB configuration parameters in DCB maps.
FC Flex IO Modules with MXL
Syntax
show dcb-map brief dcb-map-name
Parameters
brief Displays an overview of currently configured DCB maps and
the operational status of the ports on which they are applied.
dcb-map-
name
Displays the DCB configuration parameters in a specified
map that is applied on Ethernet (FCoE) ports.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.3(0.0) Introduced on the FC Flex IO module installed in the MXL
10/40GbE Switch.
Usage
Information
Use the show dcb-map command to display the enhanced transmission selection
(ETS) and priority-based flow control (PFC) parameters used to configure Ethernet
(FCoE) ports in a converged network.
You can also configure and apply a different DCB map with other PFC and ETS
settings to customize the handling of CEE traffic on specified ports (dcb-map
command).
The following table describes the show dcb-map brief and show dcb-map
output shown in the example below.
Field Description
DCB Map Name Name of a DCB map.
Interface Ethernet interface on which DCB map has been applied.
Status Operational status of the interface: enabled (active) or
disabled (not active).
Priority Group Number of an 802.1p traffic group.
Priorities 802.1p priority traffic assigned to the group.
Bandwidth Percentage of available bandwidth allocated to the specified
group.
PFC-enabled
priorities
802.1p priority traffic on which PFC is enabled.
Example
Dell# show dcb-map brief
Dcb-map-name Interface Status
dcbmapABC te 0/0 Active
FC Flex IO Modules
1375