Dell MXL 10GbE - Page 193

Parameters
any Enter the keyword any to forward all packets.
host Enter the keyword host then a MAC address to forward
packets with that host address.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
(OPTIONAL) Specify which bits in the MAC address must
match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
mac-
destination-
address
Enter the destination MAC address and mask in
nn:nn:nn:nn:nn:nn format.
mac-
destination-
address-mask
Specify which bits in the MAC address must be matched.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
ethertype
operator
(OPTIONAL) To filter based on protocol type, enter one of
the following Ethertypes:
• ev2 - is the Ethernet II frame format
• llc - is the IEEE 802.3 frame format
• snap - is the IEEE 802.3 SNAP frame format
count (OPTIONAL) Enter the keyword count to count packets the
filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
Defaults Not configured.
Command
Modes
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
deny — configures a MAC ACL filter to drop packets.
seq — configure a MAC ACL filter with a specified sequence number.
Access Control Lists (ACL)
193