EasyManua.ls Logo

Dell MXL 10GbE - Page 565

Dell MXL 10GbE
1545 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Parameters
interface,
interface,...
Enter the keywords interface range and one of the
interfaces — slot/port, port-channel, or VLAN number. Select
the range of interfaces for bulk configuration. You can enter
up to six comma-separated ranges. Spaces are not required
between the commas. Comma-separated ranges can
include VLANs, port-channels, and physical interfaces.
Slot/Port information must contain a space before and after
the dash. For example, interface range
gigabitethernet 0/1 - 5 is valid; interface range
gigabitethernet 0/1-5
is NOT valid.
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When creating an interface range, interfaces appear in the order they are entered;
they are not sorted. The command verifies that interfaces are present (physical) or
configured (logical).
Important Points to Remember:
Bulk configuration is created if at least one interface is valid.
Non-existing interfaces are excluded from the bulk configuration with a
warning message.
The interface range prompt includes interface types with slot/port
information for valid interfaces. The prompt allows for a maximum of 32
characters. If the bulk configuration exceeds 32 characters, it is represented by
an ellipsis ( ... ).
When the interface range prompt has multiple port ranges, the smaller port
range is excluded from the prompt.
If overlapping port ranges are specified, the port range is extended to the
smallest start port and the biggest end port.
Interfaces
565

Table of Contents

Related product manuals