Dell MXL 10GbE - Page 657

Parameters
name Enter the name for the transform set.
ah-
authentication
Enter the keywords ah-authentication then the
transform type of operation to apply to traffic. The transform
type represents the encryption or authentication applied to
traffic.
• md5 — Use Message Digest 5 (MD5) authentication.
• sha1 — Use Secure Hash Algorithm 1 (SHA-1)
authentication.
• null — Causes an encryption policy configured for the
area to not be inherited on the interface.
esp-
authentication
Enter the keywords esp-authentication then the
transform type of operation to apply to traffic. The transform
type represents the encryption or authentication applied to
traffic.
• md5 — Use Message Digest 5 (MD5) authentication.
• sha1 — Use Secure Hash Algorithm 1 (SHA-1)
authentication.
• null — Causes an encryption policy configured for the
area to not be inherited on the interface.
esp-encryption Enter the keywords esp-encryption then the transform
type of operation to apply to traffic. The transform type
represents the encryption or authentication applied to traffic.
• 3des — Use 3DES encryption.
• cbc — Use CDC encryption.
• des — Use DES encryption.
• null — Causes an encryption policy configured for the
area to not be inherited on the interface.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
• Both sides of the link must specify the same transform set.
• You can create up to 64 transform sets.
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
Internet Protocol Security (IPSec)
657