Dell MXL 10GbE - Page 686

Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Loopback interface, enter the keyword Loopback
then a number from 0 to 16383.
• For the Null interface, enter the keyword null then zero
(0).
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For stacking, enter the keywords stack-unit then the
stack-unit ID.
• For a tunnel interface, enter the keyword tunnel then
the tunnel ID.
• For a VLAN interface, enter the keyword VLAN.
• For a port channel interface, enter the keywords port-
channel.
brief (OPTIONAL) View a summary of IPv6 interfaces.
configured (OPTIONAL) View information on all IPv6 configured
interfaces.
gigabitethernet (OPTIONAL) View information for an IPv6 gigabitethernet
interface.
linecard slot/
port
(OPTIONAL) View information for a specific IPv6 linecard or
stack-unit. The range is 0 to 11.
managementet
hernet slot/
port
(OPTIONAL) View information on an IPv6 Management port.
Enter the slot number (0-1) and port number zero (0).
loopback (OPTIONAL) View information for IPv6 Loopback interfaces.
port-channel (OPTIONAL) View information for IPv6 port channels.
tengigabitether
net
(OPTIONAL) View information for an IPv6 tengigabitethernet
interface.
fortyGigE (OPTIONAL) View information for an IPv6
fortygigabitethernet interface.
vlan (OPTIONAL) View information for IPv6 VLANs.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
686
IPv6 Basics