Dell MXL 10GbE - Page 853

static (OPTIONAL) Enter the keyword static to display only those
MAC addresses specifically configured on the switch.
Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan
vlan-id.
address mac-
address
(OPTIONAL) Enter the keyword address then a MAC
address in the nn:nn:nn:nn:nn:nn format to display
information on that MAC address.
interface
interface
(OPTIONAL) Enter the keyword interface then the
interface type, slot and port information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
interface
interface-type
(OPTIONAL) Instead of entering the keyword interface
then the interface type, slot and port information, as above,
you can enter the interface type, then just a slot number.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to
display the MAC address assigned to the VLAN. The range is 1
to 4094.
count (OPTIONAL) Enter the keyword count, then optionally, by an
interface or VLAN ID, to display total or interface-specific
static addresses, dynamic addresses, and MAC addresses in
use.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show mac-address-table command shown in the
following example.
Column Heading Description
VlanId Displays the VLAN ID number.
Mac Address Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Type Lists whether the MAC address was manually configured
(Static), learned dynamically (Dynamic), or associated with a
specific port (Sticky).
Layer 2
853