Row Heading Description
Hello-Q The queue, for transmission or reception, for the hello
packets.
LSR-Q The queue, for transmission or reception, for the link state
request packets.
Other-Q The queue, for transmission or reception, for the link state
acknowledgement, database description, and update
packets.
The following describes the error definitions for the show ip ospf statistics
process-id global command.
Error Type Description
Intf_Down Received packets on an interface that is either down or
OSPF is not enabled.
Non-Dr Received packets with a destination address of ALL_DRS
even though SELF is not a designated router.
Self-Org Receive the self originated packet.
Wrong_Len The received packet length is different to what was
indicated in the OSPF header.
Invld-Nbr LSA, LSR, LSU, and DDB are received from a peer which is
not a neighbor peer.
Nbr-State LSA, LSR, and LSU are received from a neighbor with stats
less than the loading state.
Auth-Error Simple authentication error.
MD5-Error MD5 error
Cksum-Err Checksum Error
Version Version mismatch
AreaMismatch Area mismatch
Conf-Issue The received hello packet has a different hello or dead
interval than the configuration.
No-Buffer Buffer allocation failure.
Seq-no A sequence no errors occurred during the database
exchange process.
Socket Socket Read/Write operation error.
Q-overflow Packets dropped due to queue overflow.
Unknown-Pkt Received packet is not an OSPF packet.
Example
Dell#show ip ospf 10 statistics global
OSPF Packet Count
Open Shortest Path First (OSPFv2 and OSPFv3)
975
To Next Page
Loading...
