6. BASIC OPERATION
107
10 Sub
Items for displaying information.
• FORMAT
Shows the format (e.g., 1920x1080/59.94I YCbCr(422) 10bit HD).
If you place this item, you can show and hide it using the GENERAL SETUP tab of the
SYS menu.
It is normally displayed in white, but if the input format is not appropriate, it turns red.
• INPUT
Shows the input signal (e.g., SDI A).
If you place this item, you can show and hide it using the GENERAL SETUP tab of the
SYS menu.
• TIME
Shows the time (e.g., TIME: 00:00:00).
If you place this item, you can select the display format using the GENERAL SETUP tab
of the SYS menu.
• DATE
Shows the date (e.g., DATE: 2000/01/01).
If you place this item, you can select the display format using the GENERAL SETUP tab
of the SYS menu.
Only one item is displayed even if you switch to simul mode.
11 Tally
Items for tally display and camera ID display.
Unarranged items are displayed with black characters. Clicking an item places the item.
Arranged items are displayed with green characters. Clicking an item selects the item.
• LABEL-1, LABEL-2
Shows the camera ID set on the CAMERA ID tab.
The default values are CAM A to CAM D and vary depending on the channel.
[See also] CAMERA ID tab →7.2.11, “Setting the Camera ID (SER27)”
• IRIS
Shows the iris set on the CAMERA ID tab.
The default values are CAM A to CAM D and vary depending on the channel.
[See also] CAMERA ID tab →7.2.11, “Setting the Camera ID (SER27)”
• TALLY-1, TALLY-2, TALLY-EXT
Shows the tally set on the TALLY tab or through the remote connector.
TALLY-EXT (EXTENDED) is a tally display with a comment of up to eight characters. You
can edit the comment on the REMOTE tab.
[See also] TALLY tab → 7.2.12, “Configuring the Tally Display (SER27)”
REMOTE tab → 7.2.8, “Setting the Remote Connector”
To Next Page
Loading...
