Leader LV5300A - Page 125

6. BASIC OPERATION
108
12 Area
Set the position and size of the selected item.
The coordinates at the upper left corner of the screen are (0, 0). Those at the lower
right corner are (1920, 1080). Based on these references, the coordinates of the upper
left corner of the item is (x0, y0), and those of the lower right corner is (x1, y1).
You can change the values using the ▲▼ key or the wheel on the mouse.
13 Option
Set the options for the selected item.
• Format
Turns on and off the format display (e.g., 1920x1080/59.94I YCbCr(422) 10bit HD).
This option cannot be displayed for an AUDIO item, EYE item, or an item on the Sub
tab.
If this is set to on, you can show and hide it using the GENERAL SETUP tab of the SYS
menu.
It is normally displayed in white, but if the input format is not appropriate, it turns red.
• Input
Turns on and off the input signal display (e.g., SDI A).
This option cannot be displayed for an AUDIO item, EYE item, or an item on the Sub
tab.
If this is set to on, you can show and hide it using the GENERAL SETUP tab of the SYS
menu.
• Time
Turns on and off the time display (e.g., TIME: 00:00:00).
This option cannot be displayed for an AUDIO item, EYE item, or an item on the Sub
tab.
If this is set to on, you can select the display format using the GENERAL SETUP tab of
the SYS menu.
• Background Transparent
Selects the transmittance of the background when the sub item is superimposed on a
picture.
When enabled, the transmittance is set to 100 %; when disabled, the transmittance is
set to 50 %.
You cannot set this option for a PIC item.
•Frame
Turns on and off the frame display of PICTURE items.