Leader LV5300A - Page 138

6. BASIC OPERATION
121
• FORMAT
Shows the format (e.g., 1920x1080/59.94I YCbCr(422) 10bit HD).
If you place this item, you can show and hide it using the GENERAL SETUP tab of the
SYS menu.
It is normally displayed in white, but if the input format is not appropriate, it turns red.
If the specified format is not received, it turns yellow.
• INPUT
Shows the input signal (e.g., SDI A).
If you place this item, you can show and hide it using the GENERAL tab of the SYS
menu.
• TIME
Shows the time (e.g., TIME: 00:00:00).
If you place this item, you can select the display format using the GENERAL tab of the
SYS menu.
• TALLY-1, TALLY-2, TALLY-EXT
Shows the tally set on the TALLY tab or through the remote connector.
TALLY-EXT (EXTENDED) is a tally display with a comment of up to eight characters. You
can edit the comment on the REMOTE tab.
[See also] TALLY tab → 7.2.12, “Configuring the Tally Display (SER27)”
REMOTE tab → 7.2.8, “Setting the Remote Connector”
• LABEL-1, LABEL-2
Shows the camera ID set on the CAMERA ID tab.
The default values are CAM A to CAM D and vary depending on the channel.
[See also] CAMERA ID tab →7.2.11, “Setting the Camera ID (SER27)”
• IRIS
Shows the iris set on the CAMERA ID tab.
The default values are CAM A to CAM D and vary depending on the channel.
[See also] CAMERA ID tab →7.2.11, “Setting the Camera ID (SER27)”
6 Other
• DATE
Place the DATE item.
The DATE item shows the date (e.g., DATE: 2000/01/01).
If you place this item, you can select the display format using the GENERAL SETUP tab
of the SYS menu.
• AUDIO
Place the AUDIO item.
• EYE
Place the EYE item.