Olivetti d-Color MF4003 User Manual

H UTILITY MODE > 6. Administrator
H-14
d-Color MF4003/MF3303
6.3.13Scan File Name Settings
Key name Function/Precondition
Function Mode Initial -
Supplementary File Name -
6.3.14Set Paper Name by User
Key name Function/Precondition
Set Paper Name by User -
Edit Paper Name It will be displayed when Set Paper Name by User is enabled.
6.3.15Enlarge Display Settings
Key name Function/Precondition
Default Enlarge Display Setting -
Enlarge Display Setting -
Apply Basic Setting to Enlarge
Display
-
6.3.16Registered Key Settings
Key name Function/Precondition
Registered Key 1 -
Registered Key 2 -
Registered Key 3 -
Registered Key 4 -
Registered Key 5 -
6.3.17Main Menu Display Settings
Key name Function/Precondition
Main Menu Display Settings -
6.3.18Preview Settings
Key name Function/Precondition
Realtime Preview -
Set key Initial display -
Original direction Setting -
Preview Display Conditions
(Standard Application)
-
Preview Display Conditions
(Registered Application)
-
6.3.19List/Counter
Key name Function/Precondition
Meter Count and Device
Confirmation Tx Settings
• The counter information is collected via CS Remote Care.
• Though this setting is enabled, the information is not sent if [Service Mode] -> [System 2] -> [Acquiring
Settings] is set to “OFF.”
Management List It will not be displayed when [Service Mode] -> [Billing Setting] -> [Management Function Choice] is set to
“Vendor 2.” (It will be displayed when the Key Counter is mounted when [Service Mode] -> [System 2] ->
[Software Switch Setting] shows that switch No.33 is set to [00000001] at Bit assignment/[01] at HEX
assignment.)
Paper Size/Type Counter -
Meter Counter List Setting will be available when [Service Mode] -> [Billing Setting] -> [Management Function Choice] shows that
“Management device 2” or “Vendor 2” is mounted.
Check Consumables List
TX Operation Log Output This is displayed when [Administrator] -> [Security] -> [TX Operation Log Setting] is set to “On.”
6.3.20Custom Function Pattern Selection
Key name Function/Precondition
Custom Function Pattern Selection When a custom function pattern is registered or imported in [Service Mode] -> [System 2] -> [Custom
Pattern], the pattern ([Custom Pattern 1] to [Custom Pattern 3]) also can be selected.
Service Manual
Y119930-3

Olivetti d-Color MF4003 Specifications

General

Brand	Olivetti
Model	d-Color MF4003
Category	Copier
Language	English