J BILLING SETTING/ENHANCED SECURITY/DEBUG SETTINGS > 2. ENHANCED
SECURITY
J-20
d-Color MF4003/MF3303
2.10Engine FW DipSW
• To make printer engine settings.
<Procedure>
1. Touch [Engine FW DipSW].
2. Touch the key that corresponds to the switch No. of the function to be set and check the key is highlighted (ON state) in reverse video.
3. Touch [END].
Normal: OFF state
Reverse: ON state
Engine FW DipSW setting list
• The following table shows DIP switches that can be set in this machine.
Switch No. Function
1 Not used
2 Not used
3 New Release Disable mode
4 Choice of full-speed print prohibited condition detected
5 Enabling high humidity WUP
6 Choice of toner empty recovery mode
7 Not used
8 Not used
9 Not used
10 Not used
11 Choice of fusing rotation while waiting
12 Choice not to conduct image stabilization
13 Choice of securing fusibility
14 Choice of unit simultaneous replacement promotion
15 Not used
16 Not used
17 Not used
18 Not used
19 Not used
20 Not used
21 Not used
22 Choice of main scan direction white line correction
23 Choice of roll belt free rotation
24 Not used
25 Choice of ACS parameter
26 Not used
27 Not used
28 Choice of destination detection disable mode
29 Not used
30 Not used
31 Choice of AT1VC high frequency
To Next Page
Loading...
Need help?
General