L TROUBLESHOOTING > 1. JAM CODE
L-13
d-Color MF4003/MF3303
Procedure
Step Action Control signal Location of electrical component
1 Initial check items - -
2 Open and close the front door of the main body. - -
1.9.499-02
Contents
JAM type Controller JAM (controller forced stop command)
JAM code 99-02
JAM detection timing 99-02 The controller transmits a forced stop command under a condition other than a paper size error
during a print cycle.
Misfeed processing
location
-
Relevant parts -
Procedure
Step Action Control signal Location of electrical component
1 Initial check items - -
2 Open and close the front door of the main body. - -
1.9.599-03
Contents
JAM type Controller JAM (image processing)
JAM code 99-03
JAM detection timing 99-03 Image stabilization not completing a job.
Misfeed processing
location
-
Relevant parts -
Procedure
Step Action Control signal Location of electrical component
1 Initial check items - -
2 Open and close the front door of the main body. - -
1.9.699-04
Contents
JAM type Controller JAM (a job reservation in the main body is not released)
JAM code 99-04
JAM detection timing 99-04 A job reservation is not released after a lapse of a given time after that a print start command has
been received.
Misfeed processing
location
-
Relevant parts -
Procedure
Step Action Control signal Location of electrical component
1 Initial check items - -
2 Open and close the front door of the main body. - -
1.9.799-05
Contents
JAM type Controller JAM (main body not starting a job)
JAM code 99-05
JAM detection timing 99-05 A waiting status is not released even with a print start command received.
Misfeed processing
location
-
Relevant parts -
Procedure
Step Action Control signal Location of electrical component
1 Initial check items - -
To Next Page
Loading...
Need help?
General