d-Color MF4003/MF3303
I SERVICE MODE > 10. System 2
I-45
Switch No. Function
188 Operation setting for print status LED
203 Setting to automatically change log-in authorization to a second user when the second user attempts card authentication
after a first user has been authenticated through card authentication.
206 Setting whether to enable Coverage Counter
226 HEX 10 Setting for allowing/prohibiting use of fax mis-sending prevention function when line is used by TEL
terminal connection devices
HEX 80 Setting for allowing/prohibiting use of functions to allow administrator to change PBX function settings
when an external line button is added for direct input of an address with the PBX function enabled
227 Setting for the display of consumable level and warning. (Control panel, PSWC, Fiery)
230 HEX 08 Setting for the display of consumable level and warning. (PSES, MIB, Printfleet, SiteAudit)
HEX 40 Setting for allowing/prohibiting use of functions for preventing a unintentional sending to a wrong
destination
10.5.1SW No.012
• Addition of the authentication device
Bit Assignment HEX Assignment Details Default value (Bit/HEX)
00000000 00 Standard 00000000 / 00
00000010 02 PKI (NIPRNet)
[Card3] choice is added in Service Mode.
00000100 04 PKI (SIPRNet)
[Card3] choice is added in Service Mode.
Reference
• [Service Mode] -> [Billing Settings] -> [Authentication Device 2]
10.5.2SW No.025
• FW function version setting
Bit Assignment HEX Assignment Details Default value (Bit/HEX)
00000000 00 FW compatible with version 1.0 00010000/10
00010000 10 FW compatible with version 2.0
Reference
• [Utility] -> [Device Information List]
10.5.3SW No.033
• Renders some functions, which were available when both administrator authentication and key counter were provided with when using the
vendor, available only with administer authentication.
Bit Assignment HEX Assignment Details Default value (Bit/HEX)
00000000 00 Available with the combination of administer authentication
and key counter.
00000000 / 00
00000001 01 Available only with administrator authentication.
Reference
• [Utility] -> [Expert Adjustment]
• [Administrator] -> [System Settings] -> [List/Counter]
10.5.4SW No.049
HEX 00 - HEX0A
• The upper limit of copies that can be input through the control panel of this machine is set.
Bit Assignment HEX Assignment Details Default value (Bit/HEX)
00000000 00 Unlimited 00000000 / 00
00000001 01 1 copy
00000010 02 3 copies
00000011 03 5 copies
00000100 04 9 copies
00000101 05 10 copies
00000110 06 20 copies
00000111 07 30 copies
00001000 08 50 copies
00001001 09 99 copies
00001010 0A 250 copies
HEX 80
• Scan setting only when Sort is selected for a copy cycle to be run with originals placed on the original glass.
To Next Page
Loading...
Need help?
General