d-Color MF4003/MF3303
K FIRMWARE > 4. Auto Update setting
K-7
4. Auto Update setting
4.1Service environment
• To use the “Auto Update setting”, the MFP must be connected to such a network environment that the firmware data can be downloaded
on the network using the SMB or http protocol.
• The Auto Update function will not operate when the MFP is under the following conditions.
• Main power switch is set to OFF.
• Sub power OFF mode (power key is orange) or ErP auto power OFF mode (power key flashes orange) enabled
• [Administrator] -> [Security] -> [Enhanced Security Mode] is set to “ON”.
• MFP is operating, or there are jobs present (including appointed jobs).
• MFP is in idle with suspended job.
• Trouble has occurred.
• Image file is in the memory.
• Model or the circuit board of the program does not match.
4.2Preparation
• For using this Auto Update setting effectively, before executing the following procedures contact with the administrator to obtain an
agreement.
• Convert the obtained firmware data to an appropriate format. Refer to “ K.3.2.1 Making the firmware data.”
• Create the program update information file (C_UpdateList.ini).
• Upload the firmware data and program update information file to the program server.
• Configure the settings related to the automatic update function in [Service Mode] -> [Machine Update Setting] -> [Machine Auto Update
setting] -> [Auto Update setting].
• For details, see “
I.18.2.1 Auto Update setting.”
4.3Rewriting of Firmware
Download
• The program server is accessed at the configured polling interval to check the program update information file.
• Compare the program update information file in the program server with that in the MFP, and starts downloading the firmware data with a
changed Version number.
Auto Update of firmware
• If the MFP power is set to ON at the scheduled update time, rewriting is executed automatically. If the power is set to OFF, no rewriting will
be executed.
To Next Page
Loading...
Need help?
General