d-Color MF4003/MF3303
K FIRMWARE > 1. Overview
K-1
KFIRMWARE
1. Overview
Rewriting of Firmware
• Methods for rewriting the firmware are shown below.
NOTE
▪ The settings in the "Utility" mode and the "Service Mode" will not be changed, when the firmware is rewritten.
<How to use a USB memory>
• Save the firmware data to a USB memory. Connect the USB to the main body directly and update the firmware.
<How to use an Internet ISW>
• “Internet ISW” is a system, which obtains firmware from the program server via the Internet to update the firmware.
• It is executed when a firmware update instruction is issued or at a predetermined time.
<How to use an Auto Update setting>
• "Auto Update" is the function, which makes the main body access the program server periodically through the network to obtain a new
firmware data, then rewrites it automatically.
• It is also possible to share the update data obtained from the network with other MFP, and operate the MFP as a program server for “the
Auto Update function.” For details, see “ I.18.2.2 Relay server setting.”
Other data
• Activate all data such as the voice data, and the loadable device driver as required in accordance with the rewriting firmware or user's
environment.
Data How to install
All data [Service Mode] -> [System 2] -> [Install Data]
Loadable device driver [Service Mode] -> [System 2] -> [Driver Install]
Confirming the firmware version
• After conducting firmware rewriting, check the firmware version No. and confirm that the firmware has been normally updated.
<Procedure>
1. Select [Service Mode] -> [Firmware Version].
2. To check the firmware version.
To Next Page
Loading...
Need help?
General