d-Color MF4003/MF3303
P THEORY OF OPERATION > 1. d-Color MF4003/MF3303
P-55
4. The second sheet of paper is taken up and fed in and the image of the fourth page of the original is printed. The first sheet of paper
stops temporarily at the re-feeding position.
5. The first sheet of paper is subject to skew correction at the registration roller section before being re-fed. The second sheet of paper is
transported into the duplex section by the reverse roller. At the same time, the third sheet of paper is taken up and fed in.
6. The image of the first page of the original is printed on the paper re-fed from the duplex section.
7. While the first sheet of paper is fed out, the third sheet of paper is taken up and fed in and the image of the sixth page of the original is
printed. The second sheet of paper being transported through the duplex section is brought to a temporary stop at the re-feeding
position.
• Steps 4 to 7 are repeated hereafter.
1.15PAPER EXIT / REVERSE SECTION
1.15.1Configuration
[1] Exit path switch solenoid (SD1) [2] Exit path switchback guide
[3] Reverse roller [4] Paper exit roller
[5] ADU forward rotation clutch (CL6) [6] ADU reverse rotation clutch (CL7)
[7] Fusing motor (M3) []
To Next Page
Loading...
Need help?
General