d-Color MF4003/MF3303
I SERVICE MODE > 9. System 1
I-42
Operation
mode
Service Mode Target user Advantages Disadvantages
Warm-up Choice of
high humidity
circumstance
6 ON Want to prevent curling
immediately after warm-up
Want to print quickly
Want to prevent curling
when humidity is high
Warm-up time is as specified value
or later
Decreases possibility curling
occurs
Productivity immediately after
warm-up decreases
Warm-up time long in high
humidity (65 seconds or less)
7 Mode 4 OFF Want to prevent curling
immediately after warm-up
Decreases possibility curling
occurs
Long warm-up time (65 seconds or
less)
ON
9.10Machine State LED Setting
• Configure the display method used when displaying the main body status with state display LEDs.
Setting item Setting value Default setting
Warning Status Type 1
Type 2
â—‹
<LED display forms for each type>
Machine State LED Setting Type 1 Type 2
Warning Status Attention
• Toner supply door open
• Toner cartridge install failure
• Toner Empty
Blinking Blinking
• Near life
• Toner Near Empty
Blinking Blinking
Malfunction code Blinking Blinking
Problem Unit Isolation Blinking Blinking
Fatal error
• Trouble code
• Jam
• Door opened
• Life stop
• Toner Empty Stop
Lit Lit
Paper Remainder Not used
9.11TP Level
• To adjust the selectivity of the touch panel.
Setting range Default setting
-2 to +2 (step: 1*) 0
<Procedure>
1. Enter the new setting from the [+] / [-] key.
• To increase sensitivity of the touch panel, increase the setting value.
• To decrease sensitivity of the touch panel, decrease the setting value.
2. Touch [END].
NOTE
â–ª
When the setting has been changed, turn off the main power switch and turn it on again more than 10 seconds after.
9.12Burn Prevention Settings
• To prompt to prevent a burn injury by displaying a message indicating that the fusing unit is at a high temperature when the right door has
to be opened in order to get rid of a paper jam.
Setting item Default setting
Enable
â—‹
Disable
To Next Page
Loading...
Need help?
General